Jensen VR185 Manual do Utilizador descarregar pdf (Página 1)

Strap

VOL

TUN/CH

MODE

BND

SAT

Screw

Mounting the Base

1. Detach remote from base/strap by pressing the release button and pull-

ing up.

2. Remove the two screws on the base that appear when the remote is

removed.

3. Position strap around steering wheel, and pull tight. Replace plate and

screws.

4. Insert battery (Lithum 2032 3-volt) into remote contol, and reinstall the

remote onto the base/strap.

REMVR185KIT

Remote Control Kit

VR185

Infrared Sensor

3.5 mm Jack

(21/64 hole or 9.2 mm drill

Installing the IR Sensor

Select a mounting location close to the steering wheel, and drill a 21/64 hole for the 3.5

mm. jack to pass through. Route the infrared sensor wire through the hole, secure the sen-

sor with double-sided sticky tape and connect to the car radio via the 3.5 mm. jack on the

back of the unit.

VOL

TUN/CH

MODE

BND

SAT

Weather Band

Tuning/Channel

Band

Volume

Mode

Satellite

Release Button

Strap

Steering Wheel Remote Control

This remote control mounts to the steering wheel and operates the basic functions of the car

radio, including volume, tuning, mode, band, satellite and weather band.

1 2

REMVR185KIT 1
Limited Warranty 2

Resumo do Conteúdo

Página 1 - REMVR185KIT

StrapWBVOLTUN/CHMODEBNDSATScrewMounting the Base1. Detach remote from base/strap by pressing the release button and pull-ing up. 2. Remove the two scr

Página 2 - Limited Warranty

This warranty does not extend to the elimination of externally generated static or noise, to the correction of antenna problems, to costs incurred for