Jensen JKRS3 Manual do Utilizador

128-70521 of 16Kit Contents(1) Control Module(1) 3 Button High Frequency Transmitters(1) 5 Button Two Way LED Based Transceiver(1) On Glass Mount Supe

128-705210 of 1610Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 VoltDoor Lock Control CircuitsThese applications r

128-705211 of 1611c. Immediately turn the ignition key OFF.d. Hold the program switch ON, then start the vehicle using the ignition key.e. When the

128-705212 of 163. Raise the hood and confirm that the remote start unit shuts down.If the unit fails this test, recheck your pin switch connection to

128-705213 of 16MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:Mechanical neutral safety switch configurations differ slightly in that they do not of

128-705214 of 1614such as the light on reminder.These situations should be carefully considered before altering the vehicle's wiring and must be

128-705215 of 16NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case, i

128-705216 of 16© 2004 Audiovox Electronics Corp., Hauppauge, NY 11788 128-7052

128-70522 of 16This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! Theunit provides wait to start i

128-70523 of 163THE TRANSCEIVER/ANTENNA ASSEMBLY:The Superheterodyne Transceiver Antenna Assembly provided with this unit allows routing from below th

128-70524 of 16Failure to connect this wire to the ignition switch side of the neutral safety switch can result in personal injury andproperty damage.

128-70525 of 16WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground sour

128-70526 of 16Brake Switch Positive Shutdown DetailYELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: You must disconnect the igni

128-70527 of 167A. Shock Sensor By Pass:If there is Shock Sensor used with an alarm system and it is not shunted during the Remote Start activationper

128-70528 of 16Green/Orange Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote

128-70529 of 16NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement ismore than 300 mA.2 Pi